Apm 2 . 8 เครื่องบินควบคุมเข็มทิศในตัว / Ublox Neo - 7m Gps สําหรับ Fpv Rc Drone
This is the new APM 2.8 autopilot module. The sensors are exactly the same as with APM2.6 however this version does not have an onboard compass which makes this version ideal for use with multicopters and rovers.
This revision of the board has no onboard compass which is designed for vehicles (especially multicopters and rovers) where the compass should be placed as far from power and motor sources as possible to avoid magnetic interference. (On fixed wing aircraft its often easier to mount APM far enough away from the motors and ESCs to avoid magnetic interference so this is not as critical but APM 2.6 gives more flexibility in that positioning and is a good choice for them too). This is designed to be used with the 3DR uBlox GPS with Compass (see option below) so that the GPS/Compass unit can be mounted further from noise sources than APM itself.
Features:
- Can be ordered with top entry pins for attaching connectors vertically or as side entry pins to slide your connectors in to either end horizontally
- Includes 3-axis gyro accelerometer and magnetometer along with a high-performance barometer
- Onboard 4 MegaByte Dataflash chip for automatic datalogging
- Optional off-board GPS uBlox LEA-6H module with Compass.
- One of the first open source autopilot systems to use Invensenses 6 DoF Accelerometer/Gyro MPU-6000.
- Barometric pressure sensor upgraded to MS5611-01BA03 from Measurement Specialties.
- Atmels ATMEGA2560 and ATMEGA32U-2 chips for processing and usb functions respectively.
Specifications:
Housing Material: Plastic
Housing Color: Gray
With housing Size: 70 x 44 x 13mm
Net Weight: 31g
GPS:
- Built-in compass GPS module
- Main chip: Ublox-7M
- With fast satellite searching speed and high precision
- Compatible with APM serial port and I2C port
- Includes round plastic shell and GPS support
Pixhawk Power Module Cable:
Power Module is a simple way of providing your APM/Arduflyer with clean power from a LiPo battery as well as current consumption and battery voltage measurements all through a 6P cable. The on-board switching regulator outputs 5.3V and a maximum of 3A from up to a 7S LiPo battery.Special for APM2.5.2 APM2.6 Pixhawk flight controller.
XT60 Plug.
Max input voltage: 30V.
Max current sensing: 90A.
Voltage and current measurement configured for 5V ADC.
Switching regulator outputs 5.3V and 3A max.
6P molex cable plugs directly to APM/Arduflyer 2.5s PM connector.
Note: The Power Module is only designed to power APM/Arduflyer a RC receiver and accessories (GPS Radio telemetry). It is not designed to power servos. Use your aircrafts own ESC/BEC for that.
Package size: 20 * 15 * 3cm / 8 * 6 * 1.2in
Package weight: 120g / 4.2 oz
Packing content:
1 * APM 2.8 Flight Controller Board w/Shell
1 * Ublox-7M GPS module w/Roud plastic shell
1 * GPS Antenna Seat
1 * Power Module Cable
#APM2.8 #ArduPilot #Mega #Internal #Flight #Controller #Built-in Compass w/ #Ublox #NEO-7M #GPS for #FPV RC #Drone #Aircraft